In my last post, I practiced polishing a Sea Heart sea bean. Now that it’s finished, I wanted to beable to wear it, but I didn’t want to drill into it or paint it. This will keep the piece as natural as possible.
To make my necklace, I used a macrame technique called Bezeling. The sea bean is thick, so I needed to make sure the bezel wrap would hold the sea heart securely. To make my ladder, I used two strands of light tan Linhasita macrame cord spaced 1 inch apart. For the alternating lark’s head knots, I used a dark green color strand.I had measured the circumference of the sea heart to estimate the length of my ladder. I erred on the short side so I can “stretch” it over the edges of the sea bean to secure it using a bit of tension. I tied the ends together using a few square knots, and I melted the ends of the excess cord with a lighter (please use it outside- it’s a smelly process). Next, I used the 2 long cords remaining to make my necklace. I tied on 2 dark brown pieces to each light tan cord, and made a half hitch sinnet for a few inches, then braided the rest to the end. I did the same with the other side. For clasps, I used a carved tagua nut hook set that was drilled vertically, so I could thread the cord into each hook, and knot the ends off. This method doesn’t require any glue, but I did singe and melt the cord ends. With this very basic type of bezel wrap around my bean, it’s pretty secure. However, I’m probably not going to wear it while surfing though, just to make sure it doesn’t pop out. It is totally waterproof, however. Gnar. I think it looks really cool, but it is a LARGE piece, so maybe only on special beachy occasions. Otherwise, you can call me Flava Flav of Cocoa Beach. Boiiiiiiiiiii.