Being a woman who surfs, I’ve noticed that most other surfer chicks just aren’t into the surfing DIY scene. There’s still a bit of an intimidation factor out there to do your own repairs.
Fixing up your own surf gear seems like something a lot of surfer girls just don’t do, and furthermore, don’t want to do for a variety of excuses. It’s a real shame, especially since these same women could probably do a killer manicure and pedicure on themselves. Trust me, THAT’S much more difficult than fixing a surfboard ding, Mr. Dude Brah.
I’m guilty of being too afraid to fix my own dings and cracks in some of my surfboards, even though I craft stuff constantly. It is a bit intimidating, but I needed to get over it. My first surfboard required some surgery right now, and I didn’t want anyone else to operate but me.
If you read this blog, you’ve seen my post about this board, my first real surfboard. Its’ tail got cracked all to hell since I’m a kook, with bonus random dirt shoved down into the cracks. The foam had also shown some water intrusion because it was beginning to turn light brown. I had FINALLY talked myself into retiring this board to the wall hanger status it deserves, but I wasn’t going to hang it up with the tail looking that nasty. And it wasn’t coming off with any cleaning. Gross.
I got out my Dremel tool and used a NEW felt polishing wheel bit. Kinda like one of those manicure pens. Perfect. It’s glass, so I wanted a light touch. Remember to wear eye protection and a mask, just like you do when cooking meth, Mr. Wizard.
The felt polishing wheel worked great, but it’s a process that takes some time and patience. I had to buff down deep into the cracks to remove the dirt, which required me to cut a little into the first layer of glass. I noticed this because the “hairs” of the fiberglass (fabric the board is wrapped in) started to pop up like hairy goosebumps. I stopped when I saw that starting to occur, but I still managed to remove the majority of the damage, which was awesome.
Next, I mixed just a little jewelry resin (I like this stuff because it’s SUPER clear, and it’s self doming, so it will spread into the cracks) and used a tiny sponge brush to “pounce” the resin into the cracks on the tail. I then used the edge to smooth the area over. I used Post-It flags to mark the area I buffed, so I wouldn’t dump extra resin over the good areas.
Done! This particular jewelry resin takes up to 3 days to cure, but it seems to work better than standard Ding Repair resin on this type of heavy gloss coat. I did this repair indoors since it’s a 100 degrees here, and I was worried that the resin wouldn’t cure correctly in the heat of the garage. I’ll just finish curing it on the wall.
This was a pretty bad “ding”, so the cleaned up version looks a lot better. I just need to keep it on the wall, and swear to no more surfboard abuse. But, just in case, I need to practice on my ding repair. I’d better check Pinterest….